Page 1 - Page 2 - Page 3 - Page 4 - Page 5 - Page 6
|
||||
|
Apply a thin coating of your favorite gasket sealer then the gasket and another layer of sealer. | |||
|
Put the bearing cover on and tighten the bolts according to specs. | |||
|
Do the same process for the pto cover plate. | |||
|
Install the new teflon guides on the shifter forks, and clean the gasket sealing surfaces. | |||
|
These are the small parts on the top of the tranny. I found that small pin at the bottom, of the tranny, so keep an eye on this one. | |||
|
This is the small hole where that small pin goes. | |||
|
Put the new seal in the extension housing using the correct tool. | |||
|
Apply your sealer/gasket/sealer, put the top back on and bolt it down. When it sets-up all I'll have to do is paint the top and were done. | |||
|
Page 1 - Page 2 - Page 3 - Page 4 - Page 5 - Page 6
|
||||